Complete overflow system complete with: anti-clogging and easily removable suction grid; directional water jet; hoses*.
It can be installed in aquariums with external sump filter and two
drain holes. Xaqua In-Out is applied externally, the tank volume remains
unaffected. The special inner conformation makes it particularly
noiseless and generates a wave effect on the water surface. For
maintenance operations, such as cleaning of the tubes or replacement of
the o-rings, is sufficient to lower the water level of 4 cm. With Xaqua
In-Out there�s no need to drill holes in the bottom glass of the
aquarium, excluding all risks of water leakage possible with
conventional overflow. It�s made of moulded plastic material with high
resistance, non-toxic and shockproof. Maximum pump capacity 2500 L/h.
Divisible into two parts to position the IN and the OUT in two different
parts of the tank. External dimensions: 12 x 5 x 6 cm.
THE PACKAGE CONTAINS:
- 1 INOUT complete with grid, support, 2 nuts and nozzle water exit.
- 1 O�ring IN (Code 4137) and 1 O�ring OUT (Code 150)
INSTALLATION: To ensure a tight seal this device is
equipped with O-RING positioned on the outside of their sockets. With
INOUT in position the two O-rings have to be in contact with the outer
side of the aquarium glass. Tighten the nuts by hand without the aid of
mechanical tools. It�s important that the holes in the glass are
perfectly calibrated to ensure the hermetic water seal. The drill
template indicates the distances of the holes and the maximum and
minimum diameter. Keep in mind that the larger the diameter of the hole
and the more attention you should have to respect the distances
indicated. Place the INOUT O-rings so that they are centered in the
hole. Clean the hoses before use. Periodically clean the pump and the
hoses to mantain the INOUT efficient.
|