|
balance
- balances
the carbonate buffer system ratio
- raises
pH without affecting calcium and alkalinity
- hydroxide
blend
Description
A frequent occurrence in reef systems is low pH, while
calcium and alkalinity are at optimal levels. Raise one and the others may
fall. One of the primary reasons for this is an improper carbonate/bicarbonate
ratio. The buffer ratio changes as a natural consequence of the buffer's
ability to counteract acidifying sources such as organic acids (produced
naturally from waste) or introduced from non-pH controlled husbandry products.
In this case, adding more buffer would unnecessarily result in a rise in alkalinity
and a drop in calcium. The first product of its kind, balance ends this see-saw
effect. It resets this ratio by converting bicarbonate into carbonate in order
to reassert a higher pH without affecting calcium level.
balance is an optimized blend of sodium and potassium
hydroxides with a NSW ratio (27:1) of sodium to potassium to avoid ionic
imbalance with long term use.
aquavitro offers other solutions designed to address the
unique challenge of raising pH in a reef environment. ions addresses the
problem of low magnesium which is a cause of low buffering pK and pH.
eight.four addresses deficiencies in pK found in competing products by
providing a properly balanced (carbonate/bicarbonate) buffer system.
Directions
balance is intended to be used to raise pH when all other
parameters (alkalinity, calcium, magnesium) are at optimal levels, but pH is
still low. The amount of balance needed to raise pH to the desired level will
vary widely, depending upon the buffering capacity and quality of your tank
water. For reference purposes only, one inner cap (7 ml) will raise 75 L (20
gallons*) of salt water by about 0.1 pH units.
Add balance in small increments, and check pH after at least
3 minutes before adding additional increments.
balance can be used daily and within minutes of
calcification, eight.four, and ions
Note: The aquavitro cap offers multiple dosing solutions
depending on the size of your system. Each inner cap thread is approximately 2
mL. The inner cap contains 7 mL, while the outer ring contains 28 mL (35 mL
when both are filled to the level of the inner cap.) When filled to the top,
the cap contains 49 mL.
Use Seachem's MultiTest: Marine pH & Alkalinity kit to
check pH.
|