Product Description:

Dimensions: 34″ long x 15″ wide x 15″ high
Uses Titanium Fleece Kit 10″
Middle Section: 16.75″ x 14.5″
Return Pump Section: 7″ x 14.5″
Total Water Volume: 31 gallons
Skimmer Water Level: 7″ to 9.5″ adjustable

Trigger Systems is proud to introduce the Titanium line of sumps and ATOs. The Titanium line, as all of Trigger Systems products, are well thought out and may just be the last sump that you will ever buy. The front end of the sump where the water enters has multiple options to configure for the exact type of filtration desired, including filter socks or a fleece roller (purchased separately). The fleece roller design takes the same approach as the Platinum line with several new enhancements, including a larger return area and ability to remove plates and clean the entire fleece area.

At first glance the Titanium line may look overwhelming, but Trigger Systems has added all of the core accessories and options and looking deeper shows the simplicity of the design. Cosmetically this line will look great in any setup. The bottom is white and the surrounding walls are smoke along with a blue top. The front and top are wrapped in a solid black to provide the best look for the build in multi-colored LEDs. The LEDs can be configured from an app or with the remote. There is a nice holder for the LED remote as well. The black wrap also allows for countersunk components on the top which looks great.

All of the plumbing fittings (input from tank, several individual in the middle section, and output to the tank) are all on plates. Blank plates are provided for all of these to allow drilling for other fitting sizes or to fill the space when the fittings are not needed. Every section of the top can be covered with clear polycarbonate lids that are counter sunk into the top brace. For dosing and ATO connection, there are six quick connect fittings. There is also a slot for a Neptune Liquid Level sensor (LLS) and if not used it also comes with a blank plate to fill the space to keep a great look!

The middle wall is move-able to custom size the two sections. This is great for setting the space needed exactly for your protein skimmer maximizing the other section of a refugium or other equipment. The middle wall is also removable to create one large section. The water height is adjustable in the front section of the sump to set the height required by the protein skimmer. There are three wire holders strategically placed to hold the wires and hoses and keep them in place while looking great. The four position probe holder and the heater holder are attached to the sump using magnets which allow you to place them wherever in the sump you want.